Typical Garage Door Issues

14March 2022

Over 1,500 times per year, the average garage door opens and closes. Over and over, that’s a lot of heavy lifting. It’s no wonder that garage door malfunctions are a typical source of frustration for most homeowners. Many frequent garage door problems, fortunately, have simple solutions that don’t necessitate professional assistance.

Even a dependable garage door will occasionally require costly repairs that cannot be accomplished by just pressing a few buttons. Some of the most frequent garage door issues are listed below.

The Opener Switch Doesn’t Work

There are a variety of reasons why your door will not move once you press the opener button. The door can be locked at any time.

Your door will not open if the lock switch is turned on.

Before opening the door again, look for the lock button and disable it.

Another possibility is that the motor is disconnected. Examine the motor, which is normally attached to a light near the ceiling. Replugging it should be sufficient to resolve the issue.

 

Photo-eye sensor damage or circuit breaker tripping are more complicated scenarios. These are two frequent issues that might cause the opener switch to malfunction.

Make sure the photo-eye sensor isn’t obstructed or obscured.

Check to see whether a fuse has blown as well. In this instance, there’s a good chance you won’t be able to switch on the garage lights.

To see if the problem is resolved, try resetting the circuit breaker.

The Keypad Isn’t Working

A keypad is not required to open every garage door. However, if yours does, these may become problematic as well. Check to determine if the batteries are dead before proceeding. Replace the batteries and try again to input your keypad number to see whether the problem has been resolved.

It’s possible that your keypad will need to be reprogrammed at some point. For instructions on how to accomplish this on your specific keypad, consult your handbook. If you don’t have the original handbook, try looking up the model online.

 

If none of these works, it’s possible that the antenna, not the keypad, is the source of the problem. The signal from the keypad is received by the antenna on the motor. Check to see if it’s pointing straight down. If you’re still having trouble getting the keypad to operate, you can hire an expert to help you figure out what’s wrong.

The Remote Control Isn’t Working

A defective remote control, like the preceding issues, can be aggravating. Batteries, like the keypad, are frequently the source of defective remote controls. Replace the batteries and check if the problem goes away right away.

It’s also possible that the remote is out of range. The motor receives a signal from the remote. The signal won’t be strong enough to work if it’s too far away. Try getting closer to see if that helps.

 

If none of these methods work, the photo-eye sensors may be defective. Check the path for obstructions, make sure it’s aligned with the front of the home, and wipe the lenses to improve signal capturing.

The garage door isn’t opening or closing.

It could be for a variety of reasons that your garage door does not respond to whatever signal you provide it.

To begin, check the batteries in the remote and keypad to rule them out as the source of the problem.

Check the garage door opener device to determine whether all lights are on and working if the batteries are fine.

Otherwise, the motor may be unplugged from the power supply or a fuse may be blown.

To begin ruling out the root of the problem, try to address these issues one at a time. If none of these helps, seek professional assistance in diagnosing the problem.

 

Without moving the door, the motor continues to run.

When you click the button to open the door, the motor may start operating, but the door does not move. It’s possible that the boundaries have been crossed in this scenario. The door will move when this happens, but the motor will continue to run after the door has stopped moving. This can happen whether the door is being opened or closed, so pay attention to the motor noises. Adjust the limitations in either case to inform the motor when to stop functioning.

It’s possible that the garage door is detached from the belt if it doesn’t move at all. To reattach the belt, you’ll need to follow particular instructions depending on the installation system you have. When someone mistakenly pulls the emergency release cord, this frequently occurs.

 

Garage Door Makes a Lot of Noise

When your garage door begins to make noises, it’s a clue that there’s a problem. Squeaking noises could indicate that the rollers need to be lubricated or that they are worn out. To service them, use a silicone-based lubricant or have the rollers replaced by a professional.


Something has gotten loose, as shown by a rattling sound.

To see if the problem is resolved, tighten all of the hardware, including nuts, bolts, and screws. A torsion spring problem might cause a popping noise.

They might make a popping sound every time the garage door opens or closes if they lose lubrication or become loose. Be aware that replacing or altering torsion springs can be dangerous and should only be done by an expert.

 

The garage door opens and closes too slowly.

Your garage door may occasionally open and close properly but at a glacial pace.

This is usually a sign of worn-out rollers or dirty tracks.

Garages in dry climates or during the winter tend to dry out or freeze faster, making it more difficult for the garage door to slide down or up the tracks.

This can be avoided by wiping out the tracks and lubricating the rollers on a regular basis.

Maintenance Guidelines for Beginners

Many garage door issues can be avoided by following a regular maintenance routine. The specific remedies you choose to address the problems can help prevent them from arising in the first place:

  • Brush and lubricate the rollers and tracks at least once a season to avoid dirt buildup and slow down wear and tear.
  • Tighten the hardware to avoid sounds and other issues caused by loose parts.
  • Make that the springs and pulleys are in good working order. Professionals should change these on a regular basis.

Consider hiring a door installer and repair specialist to care for your garage door if none of these ideas work or if you’d prefer to have someone else deal with the situation.

One Reply to “Typical Garage Door Issues”

Leave a Reply

Your email address will not be published.